If you need immediate assistance, please call
1-800-295-2392 or click below to call one of our regional representatives. Call Regional Customer Service Representative

Click here to view our privacy policy

If you need immediate assistance, please call
1-800-295-2392 or click below to call one of our regional representatives. Call Regional Customer Service Representative

Click here to view our privacy policy

SAG™ 1538 Antifoam Compound

SILICONE ANTIFOAM COMPOUND FOR NON-AQUEOUS IN-CAN FORMULATIONS

Containing 100% actives, SAG 1538 antifoam compound is highly effective as a foam-control agent in non-aqueous, hard-to-defoam surfactant concentrates, such as those containing organic surfactants and electrolytes, where it offers initial and long-lasting foam control. SAG 1538 antifoam compound can also perform well over a broad pH range. 

Key Features and Typical Benefits

  • 100% actives
  • Exceptional defoaming performance in most foaming systems
  • Rapid defoaming when the antifoam is initially applied to the foaming system
  • Long-lasting foam inhibition
  • Good performance over a broad pH range
  • EPA 40 CFR §180.910 approved inert ingredient

+
  • Technical Documents

SAG 1572
SAG™ 1538 Marketing Bulletin
DOWNLOAD

More About SAG™ 1538 Antifoam Compound

A versatile product, it typically is highly effective as a foam-control agent in hard-to-defoam surfactant concentrates, such as those containing organic surfactants and electrolytes, and performs well over a broad pH range. SAG 1538 antifoam also offers the potential benefits of high antifoam potency in the majority of foaming systems and long-lasting foam inhibition.

Although SAG 1538 antifoam is not immediately dispersible in water, it can be easily incorporated into surfactant concentrates by using the surfactants within the system to stabilize the antifoam within the formulation. When adding SAG 1538 antifoam to these concentrates, it should be applied slowly to moderate agitations to ensure a complete and homogenous dispersion of the antifoam. 

Use levels for SAG 1538 antifoam in a final foaming system will be dependent upon the nature of the foaming system and/or the agitation that causes the generation of the foam. It is recommended to add a sufficient level of SAG 1538 antifoam at the starting point in order to achieve a final foaming formulation of between 5 ppm and 20 ppm.

For key features, typical benefits and physical properties, potential applications and more, please download the marketing bulletin on this page.

* SAG is a trademark of Momentive Performance Materials Inc.

 

 

Explore: SAG™
View Brand
Explore: Agriculture
View Industry

Not the product you are looking for? Please visit:

All Industries  / All Products
* Silplusは、新日鉄住金化学株式会社の商標であり、許可を得て使用しています。

*The marks followed by an asterisk (*) are trademarks of Momentive Performance Materials Inc.